Finally My Radio room
Finally My Radio room
This is my main corner, I have consoles and table tops stored on the other side of the shelving, and I store my tubes and tube testers in the closet. I have two bookshelves also loaded with Sams Transistor manuals and Riders Manuals, along with a ton more of books just on radios and electronics.

I will be doing further sorting and arranging to make it look better.
This is the Extra storage shelve if you were to do a 180 degree turnaround.


I will be doing further sorting and arranging to make it look better.
This is the Extra storage shelve if you were to do a 180 degree turnaround.

Last edited by Resistance is Futile on Fri Jan 04, 2013 11:45 pm; edited 5 times in total
Resistance is Futile- Member
- Number of posts : 913
Registration date : 2008-03-12
Re: Finally My Radio room
You did but the first one was too big so I'm learning to re-size and upload my Pics.
This is the backside storage for consoles and desktops.

This is the backside storage for consoles and desktops.

Resistance is Futile- Member
- Number of posts : 913
Registration date : 2008-03-12
Re: Finally My Radio room
Looks nice and comprehensive, Cliff.
N7ZAL- Member
- Number of posts : 493
Registration date : 2011-11-05
Re: Finally My Radio room
Cliff,
Looks like you have some wonderful test equipment there
Looks like you have some wonderful test equipment there

Dr. Radio- Member
- Number of posts : 899
Age : 40
Registration date : 2012-09-17
Re: Finally My Radio room
I like the shelf to put your extra stuff instead of piled on your bench .
Ken g- Member
- Number of posts : 222
Registration date : 2009-01-30
Re: Finally My Radio room
You don't seem to have far to reach for anything too by the looks of the photos. I like that idea as well.
ve1arn- Member
- Number of posts : 137
Age : 70
Registration date : 2008-03-12
Re: Finally My Radio room
WOOPS .........you bench is piled

Ken g- Member
- Number of posts : 222
Registration date : 2009-01-30
Re: Finally My Radio room
What I would like to do is get a deeper bench. I may use a door and make some sturdy shelves on top for some of the test equipment. Will use either 2X6 or 4X4 for legs.
The bench you see is one I got as a kit from Harbor freight. It has four drawers that have ball bearing sliders. That's about the only good thing. It's very cheaply made otherwise. And metal too, not safe for electrical use. I put some cardboard on the top, just to insulate.
The bench you see is one I got as a kit from Harbor freight. It has four drawers that have ball bearing sliders. That's about the only good thing. It's very cheaply made otherwise. And metal too, not safe for electrical use. I put some cardboard on the top, just to insulate.
Resistance is Futile- Member
- Number of posts : 913
Registration date : 2008-03-12
Permissions in this forum:
You cannot reply to topics in this forum
|
|