Heathkit SG8 Signal Generator

View previous topic View next topic Go down

Heathkit SG8 Signal Generator

Post by cncfan on Thu May 11, 2017 2:56 am

Hi  
I just won an auction for a Heathkit SG8 and going to re-cap it.

Looking over the current caps. Have one listed as .02ufd at 800 volts.  I can not find a .02 ufd at 800 volts cap. Did find a .02uF at 1000 volts.  Would this work at being 200 volts above what is called for?



Thanks for any input you may have.


Last edited by cncfan on Thu May 11, 2017 3:11 am; edited 1 time in total (Reason for editing : Removed text)

cncfan
New Member
New Member

Number of posts : 7
Age : 69
Registration date : 2017-04-22

Back to top Go down

Re: Heathkit SG8 Signal Generator

Post by John Bartley on Thu May 11, 2017 8:09 am

Yes, the 1000v replacement will do just fine.

John Bartley
Member
Member

Number of posts : 133
Registration date : 2013-04-21

Back to top Go down

Re: Heathkit SG8 Signal Generator

Post by cncfan on Thu May 11, 2017 10:25 am

Thank you John.
George

cncfan
New Member
New Member

Number of posts : 7
Age : 69
Registration date : 2017-04-22

Back to top Go down

Re: Heathkit SG8 Signal Generator

Post by Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum