rewiring a new tuning eye 6U5 tube socket to a 11-S-474 Zen chassis.

View previous topic View next topic Go down

rewiring a new tuning eye 6U5 tube socket to a 11-S-474 Zen chassis.

Post by davidcharris on Fri Nov 23, 2012 2:46 pm

Hi everyone ! I recently picked up a 11-S-474 Zenith and noticed that someone had cut out the wiring harness for the 6U5 tuning eye tube. I have picked up a used socket with the wiring connected but I don't know where the five (5) wires connect from each tube/pin in the chassis to their respective pins in the 6U5 socket. Any help or references would be greatly appreciated ! Thanks !

David

davidcharris
New Member
New Member

Number of posts : 1
Registration date : 2012-11-23

Back to top Go down

Re: rewiring a new tuning eye 6U5 tube socket to a 11-S-474 Zen chassis.

Post by Guest on Fri Nov 23, 2012 4:59 pm

Here is a schematic representation of the tube with the pin out. The filament pins should be easy to find with a ohmmeter.

http://tubedata.milbert.com/sheets/127/6/6U5.pdf

Guest
Guest


Back to top Go down

Re: rewiring a new tuning eye 6U5 tube socket to a 11-S-474 Zen chassis.

Post by sprman on Sat Nov 24, 2012 12:10 pm

Dont forget to check the 1 meg resistor for the eye tube they like to change value or go open.Sprman

sprman
Member
Member

Number of posts : 374
Age : 62
Registration date : 2008-03-27

Back to top Go down

Re: rewiring a new tuning eye 6U5 tube socket to a 11-S-474 Zen chassis.

Post by Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum