Voltage down

Philco model 111 voltage at electrolytic caps around 475 .Checked filter choke checks good resistors check good.
This will probaly put a strain on transformer &80 recitifier tube . Any way i can get voltage down in the line ?e
Checked everything for a short it calls for a 4.7uf@450 volts . Keeps blowing it . Put a 20mfd@450 doesn,t blow.
THIS IS ON TERMINAL 10 IN BIG CAP BLOCK. The other electrolytic cap from terminal 9 to 3 does fine.
Any ideals THANKS DENVER.

oh 10 also goes to 3 THE REST OF CAPS PUT WHAT SCHAMATIC CALLS FOR MAYBE YOULL UNDERSTAND THIS
1&2 TERMS TIE TOGETHER GOES TO #11 #4 #5 #6 #7 TO#11 THEN #8 TO#9 TO# 3 THEN # 10 TO #3 IN BIG CAP BLOCK ALL RATED AT 630 VOLTS EXCEPT ELECTROLYTIC CAPS 450VOLTS #11 CHASSI GROUND
RAN POLARITY RIGHT ON THE ELECTROLYTICS

OK check the speaker field coil to see if its shorted.Look at the 80 output that goes to 2 resistors check them.Have you ckecked tube socket resistanes for all tubes.Check the 45 tubes sockets for shorts to ground same with the 80.Check for and globs of solder that might short out to ground.Sprman : )

WILL DO LET YOU KNOW
THANKS DENVER

THANKS SPRMAN LED ME ON TO SOMETHING .
THIS IS A BIG CONSOLE I WAS CHECKING VOLTAGE WITH SPEAKER UNHOOKED. DIDN,T WANT TO TAKE SPEAKER OUT
ITS A BIS ONE. HARD TO CHECK WITH SPEAKER IN RADIO
MANAGE TO VOLTAGE ALL RIGHT . I WAS CHECKING WITH NO LOAD ON CHOKE .
THANKS DENVER

Ahh yes have done that myself befor.Hope it plays good for you.Sprman : )